OBD-II trouble code · Powertrain (engine and transmission)

P0443 Evaporative Emission Control System Purge Control Valve Circuit Malfunction

The engine computer found an electrical problem with the EVAP purge valve circuit, the valve that lets stored fuel vapor flow into the engine. It is usually a failed valve coil, wiring, or a connector issue.

SeverityLow
Safe to drive?Generally safe to drive, though if the valve is stuck open you may notice rough idle or hard starting after refueling; get it repaired to pass inspection. If you smell strong raw fuel or see fuel leaking, stop driving and have it inspected by a pro, because that is a fire risk.

There's an electrical hiccup in my purge valve circuit. Check my connector and wiring first, and if they're fine, the valve itself probably needs replacing.

— FRED, speaking as your car

What P0443 means

The evaporative emission (EVAP) system traps fuel vapors from the fuel tank in a charcoal canister and later draws them into the engine to be burned, instead of letting them escape into the air. The purge valve is an electric solenoid the PCM switches on and off. The PCM monitors the circuit voltage or current, and this code was set because the circuit reading did not match the commanded state, such as an open or shorted circuit. Unlike leak codes, this is an electrical fault. Circuit designs vary by make.

Common symptoms

  • Check engine light on
  • Usually no change in drivability
  • Possible rough idle or hard start after refueling
  • Possible other EVAP codes
  • Failed emissions inspection

Likely causes (most likely first)

  1. Failed purge valve solenoid (open or shorted coil)
  2. Damaged or corroded purge valve connector
  3. Broken, chafed, or shorted wiring
  4. Blown fuse for the EVAP circuit (on some vehicles)
  5. PCM driver fault (rare)

What you can check yourself

  1. Locate the purge valve, usually near the intake manifold or throttle body
  2. Inspect the connector for corrosion, loose pins, or a broken lock tab
  3. Inspect wiring near hot or moving parts for damage
  4. Check related fuses using the owner's manual chart
  5. Measure the solenoid coil resistance with a multimeter and compare to spec for your vehicle
  6. Use a scan tool to command the valve and listen for clicking

FRED reads freeze frame and live data, so you can see what the engine was doing when P0443 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace purge valve$120–$300
Repair purge valve wiring or connector$100–$300
Diagnostic testing at a shop$100–$200

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0443 FAQ

No. It is an electrical circuit problem with the purge valve, not a vapor leak, although a failed valve can also cause flow or leak codes.
On many vehicles it is mounted in an accessible spot near the engine and is a fairly simple replacement, but location varies.

Related codes