OBD-II trouble code · Powertrain (engine and transmission)

P0328 Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor)

The knock sensor signal is stronger than the computer expects. This can be a wiring problem, a faulty sensor, or real engine noise that the sensor is picking up.

SeverityModerate
Safe to drive?Generally okay for short, gentle driving, but if you hear pinging or knocking under load, ease off and get it checked soon, since real knock can damage pistons.

My knock sensor is hearing more noise than it should, so either something is rattling or I'm actually pinging. Let's check my fuel and listen closely before swapping parts.

— FRED, speaking as your car

What P0328 means

The knock sensor converts engine vibration into an electrical signal. P0328 sets when the engine computer sees the knock sensor 1 signal above its expected range. This can be caused by wiring shorted to a voltage source, a failing sensor, or excessive mechanical noise such as a loose heat shield, valvetrain noise, or actual detonation from low-octane fuel or carbon buildup. When this code sets, the computer typically retards timing as a precaution. On V engines, bank 1 is the side with cylinder 1. Details vary by make.

Common symptoms

  • Check-engine light on
  • Reduced power
  • Lower fuel economy
  • Audible pinging or knocking when accelerating
  • Rattling or ticking from the engine area

Likely causes (most likely first)

  1. Wiring shorted to voltage or interference from nearby circuits
  2. Failed knock sensor
  3. Real engine knock from low-octane fuel, overheating, or carbon buildup
  4. Loose components or heat shields creating vibration
  5. Valvetrain or internal engine noise
  6. Engine computer fault (rare)

What you can check yourself

  1. Make sure you are using the fuel grade your owner's manual recommends
  2. Listen for pinging under load and rattles from heat shields or brackets
  3. Check coolant level and that the engine is not running hot
  4. Inspect knock sensor wiring for chafing against other wires or hot parts
  5. Look at live timing data; heavy timing retard can point to real knock
  6. Clear the code and see if it returns after fixing any obvious issues

FRED reads freeze frame and live data, so you can see what the engine was doing when P0328 set, before you buy any parts.

Typical repair costs

RepairTypical range
Repair wiring or connector$100–$400
Replace knock sensor (easy access)$150–$400
Replace knock sensor (under intake manifold)$400–$1,000
Carbon cleaning service$150–$500
Secure loose heat shields or brackets$50–$200

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0328 FAQ

It can on some engines, since the sensor picks up vibration. Fixing rattles is cheap and worth checking first.
Use the grade your owner's manual recommends. If your car calls for premium and you have been using regular, that may be contributing.

Related codes