OBD-II trouble code · Powertrain (engine and transmission)

P0325 Knock Sensor 1 Circuit Malfunction (Bank 1 or Single Sensor)

The sensor that listens for harmful engine knock is not sending a signal the computer trusts. The engine may run with less power or worse mileage because the computer plays it safe with spark timing.

SeverityModerate
Safe to drive?Generally safe to drive in the short term, but avoid heavy loads and use the recommended fuel grade, because the engine cannot protect itself from knock as well until it is fixed.

My knock sensor isn't reporting in, so I'm being extra careful with my spark timing. You might notice I feel a little lazier until it's fixed.

— FRED, speaking as your car

What P0325 means

A knock sensor is a small microphone-like sensor bolted to the engine block that detects the vibration of abnormal combustion, often called knock or pinging. The engine computer uses it to pull back spark timing when knock happens. P0325 sets when the computer sees a problem in the knock sensor 1 circuit, such as no signal, an open or shorted wire, or a signal outside expected range. When this happens, the computer usually retards timing as a precaution. On V engines, bank 1 is the side with cylinder 1; sensor location and testing details vary by make.

Common symptoms

  • Check-engine light on
  • Reduced power or sluggish acceleration
  • Lower fuel economy
  • Pinging or knocking sound under load in some cases
  • Engine otherwise runs normally

Likely causes (most likely first)

  1. Failed knock sensor
  2. Damaged, corroded, or disconnected wiring or connector
  3. Sensor not torqued correctly to the block
  4. Wiring harness damaged by heat or rodents
  5. Actual engine knock or mechanical noise (less common for this code)
  6. Engine computer fault (rare)

What you can check yourself

  1. Scan for other codes, especially other knock sensor codes
  2. Find the sensor location for your engine; some are easy to reach and some sit under the intake manifold
  3. Inspect the visible wiring and connector for damage, corrosion, or rodent chewing
  4. Check that you are using the fuel grade your owner's manual recommends
  5. Measure sensor resistance or signal with a multimeter if the service manual gives specs
  6. Clear the code and see if it returns under similar driving conditions

FRED reads freeze frame and live data, so you can see what the engine was doing when P0325 set, before you buy any parts.

Typical repair costs

RepairTypical range
Repair knock sensor wiring or connector$100–$400
Replace knock sensor (easy access)$150–$400
Replace knock sensor (under intake manifold)$400–$1,000
Diagnose engine noise or knock$100–$250

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0325 FAQ

Usually the computer retards timing to protect the engine, which costs power and mileage. Damage risk goes up if the engine is actually knocking, especially under heavy load or with low-octane fuel.
On many V6 and V8 engines, the knock sensors are under the intake manifold, so the manifold has to be removed to reach them.

Related codes