OBD-II trouble code · Powertrain (engine and transmission)

P0327 Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor)

The knock sensor signal is weaker than the computer expects, as if the sensor is quiet or the wire is broken or shorted to ground. The computer will likely reduce timing, which can cost power and fuel economy.

SeverityModerate
Safe to drive?Generally safe to drive short term, but avoid heavy loads and use the recommended fuel grade, since knock protection is reduced until it is repaired.

My knock sensor is whispering too quietly for me to trust it, so I'm dialing back my timing to stay safe. A wiring check is a good first step.

— FRED, speaking as your car

What P0327 means

The knock sensor produces a small electrical signal from engine vibration. P0327 sets when the engine computer sees that signal for knock sensor 1 below the expected range, which usually points to an open circuit, a short to ground, a poor connection, or a failed sensor. A sensor that is loose on the block can also produce a weak signal. On V engines, bank 1 is the side with cylinder 1. Sensor location, specifications, and test procedures vary by make.

Common symptoms

  • Check-engine light on
  • Reduced power or sluggish acceleration
  • Lower fuel economy
  • Possible pinging under load
  • Engine otherwise runs normally

Likely causes (most likely first)

  1. Open or shorted-to-ground wiring
  2. Corroded or loose connector
  3. Failed knock sensor
  4. Sensor loose or improperly torqued on the block
  5. Damaged harness from heat, oil, or rodents
  6. Engine computer fault (rare)

What you can check yourself

  1. Scan for related knock sensor codes and note freeze-frame data
  2. Locate the sensor and inspect wiring and connector for damage or corrosion
  3. Check sensor mounting bolt tightness if accessible, using the specified torque
  4. Test the wiring for continuity and shorts to ground with a multimeter
  5. Check sensor resistance if your service manual provides a spec
  6. Clear the code and test drive to see if it returns

FRED reads freeze frame and live data, so you can see what the engine was doing when P0327 set, before you buy any parts.

Typical repair costs

RepairTypical range
Repair wiring or connector$100–$400
Replace knock sensor (easy access)$150–$400
Replace knock sensor (under intake manifold)$400–$1,000
Diagnostic testing$100–$200

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0327 FAQ

Either is possible. Wiring and connector problems are common, so inspect and test the circuit before buying a sensor.
No. Unplugging it removes knock protection and will keep the code on. The computer will run reduced timing, and the engine may be more vulnerable to damage.

Related codes