OBD-II trouble code · Powertrain (engine and transmission)
P0133 O2 Sensor Circuit Slow Response Bank 1 Sensor 1
Your upstream oxygen sensor on bank 1 is reacting too slowly to changes in the exhaust. Aging sensors commonly cause this code.
My bank 1 upstream oxygen sensor is getting a bit sluggish. A fresh one should help me fine-tune my fuel again.
— FRED, speaking as your car
What P0133 means
P0133 sets when the bank 1 sensor 1 signal takes too long to switch between rich and lean, or to respond to fuel changes. This usually means the sensor has aged or become contaminated, though exhaust leaks and fuel problems can also contribute. Response time thresholds vary by make, and wide-band sensors are tested differently.
Common symptoms
- Check-engine light on
- Reduced fuel economy
- Slight hesitation
- Failed emissions test
- Often no noticeable symptoms
- Possible rich or lean codes
Likely causes (most likely first)
- Aged or worn upstream O2 sensor
- Contaminated sensor (oil, coolant, or additives)
- Exhaust leak near the sensor
- Wiring or connector issue
- Faulty O2 heater circuit
- Vacuum or fuel delivery problem
What you can check yourself
- View live O2 data on a warm engine; look for slow or lazy switching
- Inspect for exhaust leaks
- Check connector and wiring condition
- Check for O2 heater codes
- Look for oil or coolant consumption
- Replace the sensor if it's original and high-mileage
FRED reads freeze frame and live data, so you can see what the engine was doing when P0133 set, before you buy any parts.
Typical repair costs
| Repair | Typical range |
|---|---|
| Replace upstream O2 sensor | $150–$400 |
| Repair exhaust leak | $100–$500 |
| Repair wiring | $100–$300 |
Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.