OBD-II trouble code · Powertrain (engine and transmission)

P0131 O2 Sensor Circuit Low Voltage Bank 1 Sensor 1

Your upstream oxygen sensor on bank 1 is reporting a voltage that stays too low. This could be a real lean condition or a sensor or wiring problem.

SeverityModerate
Safe to drive?Usually safe to drive short-term, but a real lean condition can cause misfires and catalytic converter damage; get it checked soon and stop if the check-engine light flashes.

My bank 1 upstream oxygen sensor keeps saying I'm lean. Let's figure out whether it's the sensor or a real leak.

— FRED, speaking as your car

What P0131 means

P0131 sets when the bank 1 sensor 1 signal stays below its expected minimum for a set time. On traditional sensors, low voltage indicates lean exhaust, so a real lean condition, vacuum leak, or exhaust leak can cause it, along with a failed sensor or shorted wiring. Wide-band sensors use different signaling, and thresholds vary by make.

Common symptoms

  • Check-engine light on
  • Poor fuel economy
  • Hesitation or rough idle
  • Possible lean codes
  • Failed emissions test
  • Often no other symptoms

Likely causes (most likely first)

  1. Faulty upstream O2 sensor
  2. Signal wire shorted to ground
  3. Exhaust leak before the sensor
  4. Vacuum leak causing real lean condition
  5. Low fuel pressure
  6. Contaminated sensor

What you can check yourself

  1. Check for P0171 or other lean codes
  2. View fuel trims; high positive trims suggest a real lean condition
  3. Inspect for exhaust leaks near the sensor
  4. Inspect wiring for chafing or shorts
  5. Briefly snap the throttle while watching live O2 data; it should respond
  6. Replace the sensor if engine conditions are normal

FRED reads freeze frame and live data, so you can see what the engine was doing when P0131 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace upstream O2 sensor$150–$400
Repair exhaust leak$100–$500
Repair vacuum leak$50–$400
Repair wiring$100–$300

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0131 FAQ

Only if the sensor is bad. If there's a real lean condition or exhaust leak, a new sensor will report the same thing.
Yes, outside air drawn into a leak before the sensor makes it read lean.

Related codes