OBD-II trouble code · Powertrain (engine and transmission)

P0022 Intake Camshaft Position Timing Over-Retarded Bank 2

The bank 2 intake camshaft is sitting later (more retarded) than the engine computer commanded. This is usually a variable valve timing, oil, or timing chain issue.

SeverityModerate
Safe to drive?Usually drivable for a short time to reach a shop, but don't ignore it because oil supply or chain wear may be involved; stop if the check-engine light flashes or the engine runs very poorly.

My bank 2 intake cam is lagging behind where I asked it to be. I can still get you around, but I'd feel a lot better after an oil check and a look at that solenoid.

— FRED, speaking as your car

What P0022 means

The PCM commands the bank 2 intake cam phaser through an oil control solenoid and checks the result with the cam position sensor. P0022 sets when the actual cam position stays more retarded than commanded beyond a set limit or time. Typical causes include a solenoid that won't open, a phaser that is stuck or worn, oil pressure or quality problems, or a stretched timing chain that has shifted cam timing. Exact test values vary by make.

Common symptoms

  • Check-engine light on
  • Reduced power, especially at low RPM
  • Rough idle
  • Worse fuel economy
  • Startup rattle on some engines
  • Hesitation on acceleration

Likely causes (most likely first)

  1. Bank 2 intake oil control solenoid stuck or failed
  2. Cam phaser stuck retarded or worn
  3. Low or dirty engine oil
  4. Clogged oil passages or solenoid screen
  5. Stretched timing chain
  6. Sensor or wiring fault

What you can check yourself

  1. Check oil level and condition
  2. Look for related correlation or VVT codes
  3. Inspect solenoid wiring and connector on bank 2
  4. Test solenoid resistance against spec
  5. Watch commanded versus actual cam angle in live data if available
  6. Change oil with the correct spec and recheck

FRED reads freeze frame and live data, so you can see what the engine was doing when P0022 set, before you buy any parts.

Typical repair costs

RepairTypical range
Oil and filter change$50–$120
Replace intake oil control solenoid (bank 2)$150–$450
Replace intake cam phaser (bank 2)$600–$1,800
Timing chain replacement$1,000–$3,500

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0022 FAQ

Both are bank 2 intake cam timing codes. P0021 means the cam is more advanced than commanded, and P0022 means it's more retarded than commanded.
Yes. A stretched chain can shift the cam later relative to the crank, which the computer reads as over-retarded.

Related codes