OBD-II trouble code · Powertrain (engine and transmission)
P0452 Evaporative Emission Control System Pressure Sensor Low Input
The fuel tank pressure sensor signal is lower than the engine computer expects. That is often caused by a faulty sensor, wiring issue, or connector problem.
The signal from my fuel tank pressure sensor is reading too low. Usually that's a wiring or sensor problem, not an actual leak.
— FRED, speaking as your car
What P0452 means
The evaporative emission (EVAP) system traps fuel vapors from the fuel tank in a charcoal canister and later draws them into the engine to be burned, instead of letting them escape into the air. The fuel tank pressure sensor sends a voltage signal that changes with pressure in the EVAP system. This code was set because the signal voltage was below the sensor's normal operating range, which usually indicates an electrical problem such as a signal wire shorted to ground, a lost reference voltage, or a failed sensor, rather than an actual vapor leak. The sensor's location and circuit design vary by make.
Common symptoms
- Check engine light on
- Usually no drivability change
- EVAP readiness monitor may not complete
- Possible other EVAP codes
- Failed emissions inspection
Likely causes (most likely first)
- Faulty fuel tank pressure sensor
- Signal wire shorted to ground
- Open or low reference voltage to the sensor
- Corroded or damaged connector
- Damaged wiring under the vehicle
- PCM fault (rare)
What you can check yourself
- Check for other sensor codes that share the same reference voltage
- With your OBD-II app, view the fuel tank pressure sensor reading; a fixed, very low reading suggests an electrical fault
- Inspect the sensor connector and wiring if accessible
- Using a wiring diagram, check reference voltage, ground, and signal at the connector with a multimeter
- Look for wiring damage where harnesses pass near the fuel tank and frame
- Clear the code and see if it returns immediately, which suggests a hard electrical fault
FRED reads freeze frame and live data, so you can see what the engine was doing when P0452 set, before you buy any parts.
Typical repair costs
| Repair | Typical range |
|---|---|
| Replace fuel tank pressure sensor (accessible location) | $150–$350 |
| Replace sensor requiring fuel tank lowering | $300–$700 |
| Repair wiring or connector | $100–$300 |
| Diagnostic testing at a shop | $100–$200 |
Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.