OBD-II trouble code · Powertrain (engine and transmission)
P0365 Camshaft Position Sensor B Circuit (Bank 1)
The engine computer found an electrical problem with camshaft position sensor B on bank 1. That sensor helps the computer know where the camshaft is for timing fuel and spark.
I'm not getting a clear signal from my bank 1 cam sensor B, so I'm guessing a bit at timing. Let's check that sensor and its plug.
— FRED, speaking as your car
What P0365 means
The camshaft position sensor tells the PCM the cam's rotation and position. P0365 sets when the PCM detects a fault in the bank 1 sensor B circuit, such as no signal, an open, a short, or a signal that doesn't match expected patterns. Sensor B is commonly the exhaust camshaft sensor, but naming varies by make. Without a good signal, the engine may run with default timing, start poorly, or stall.
Common symptoms
- Check-engine light on
- Hard starting or long cranking
- Stalling
- Rough idle
- Reduced power
- Poor fuel economy
Likely causes (most likely first)
- Faulty camshaft position sensor B (bank 1)
- Damaged or oil-soaked connector
- Open or shorted wiring
- 5-volt reference or ground problem
- Damaged reluctor or tone wheel
- Rarely, PCM fault
What you can check yourself
- Scan for other cam, crank, or VVT codes
- Locate the bank 1 sensor B and inspect its connector for oil, corrosion, or damage
- Inspect wiring for chafing
- Check for 5-volt reference and ground at the connector with a multimeter
- Remove the sensor and check its tip for debris or damage
- Clear the code and see if it returns
FRED reads freeze frame and live data, so you can see what the engine was doing when P0365 set, before you buy any parts.
Typical repair costs
| Repair | Typical range |
|---|---|
| Repair wiring or connector | $100–$300 |
| Replace camshaft position sensor | $100–$300 |
| Replace damaged tone wheel (if accessible) | $300–$1,200 |
Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.