OBD-II trouble code · Powertrain (engine and transmission)

P0366 Camshaft Position Sensor B Circuit Range/Performance (Bank 1)

The signal from camshaft position sensor B on bank 1 doesn't look right to the engine computer. The sensor is sending something, but it's erratic or out of pattern.

SeverityModerate
Safe to drive?Short trips to a shop are usually OK, but stalling and hard starts can happen; stop and get help if you hear rattling or the engine runs badly.

My bank 1 cam sensor B is sending me a jumpy signal. Could be the sensor, could be my timing, so let's check before I start stalling.

— FRED, speaking as your car

What P0366 means

The PCM expects a specific pattern from the camshaft position sensor that matches the crankshaft sensor. P0366 sets when the bank 1 sensor B signal is present but irregular, noisy, or out of expected range. Possible causes include a failing sensor, wiring interference, a damaged tone ring, or a timing problem like chain stretch. Sensor B is often the exhaust cam, but this varies by make.

Common symptoms

  • Check-engine light on
  • Hard starting
  • Intermittent stalling
  • Rough idle
  • Hesitation
  • Reduced power

Likely causes (most likely first)

  1. Failing camshaft position sensor B (bank 1)
  2. Wiring interference or poor connection
  3. Damaged or loose tone ring
  4. Timing chain stretch or jumped timing
  5. Incorrect sensor air gap or wrong part
  6. Oil contamination in connector

What you can check yourself

  1. Scan for correlation codes like P0017
  2. Inspect sensor connector and wiring for damage or oil
  3. Check sensor mounting for looseness
  4. Remove the sensor and inspect for debris
  5. Watch for intermittent signal dropouts with a wiggle test if your scanner shows RPM or cam signals
  6. Listen for timing chain rattle at startup

FRED reads freeze frame and live data, so you can see what the engine was doing when P0366 set, before you buy any parts.

Typical repair costs

RepairTypical range
Repair wiring or connector$100–$300
Replace camshaft position sensor$100–$300
Replace tone ring or related parts$300–$1,200
Timing chain replacement (if timing is off)$1,000–$3,000

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0366 FAQ

P0365 is a general circuit fault. P0366 means the signal exists but is erratic or out of range.
Yes. Poor quality or incorrect sensors can produce signals the computer rejects. Use a part that matches your engine's specification.

Related codes