OBD-II trouble code · Powertrain (engine and transmission)

P0301 Cylinder 1 Misfire Detected

Cylinder 1 in your engine is not firing correctly, so it is not contributing its share of power. This is usually caused by a spark plug, ignition coil, or fuel injector problem on that cylinder.

SeverityHigh
Safe to drive?With a steady check-engine light you can drive gently to a shop, but if the light is flashing, stop driving, because unburned fuel can overheat and ruin the catalytic converter.

My cylinder 1 isn't firing right, so I'm running on fewer cylinders than I should. Let's check its spark plug and coil first, they are the usual suspects.

— FRED, speaking as your car

What P0301 means

The engine computer tracks crankshaft speed and notices when the power stroke from a specific cylinder is weak or missing. When cylinder 1 misfires often enough to affect emissions or risk catalytic converter damage, the computer sets P0301. Because the problem is limited to one cylinder, the cause is usually a part dedicated to that cylinder, such as its spark plug, coil, or injector, or a mechanical problem like a leaking valve. Which cylinder is number 1 and how misfires are detected vary by make, so check a service manual or diagram for your engine.

Common symptoms

  • Check-engine light on or flashing
  • Rough idle or shaking
  • Hesitation or stumble when accelerating
  • Reduced power
  • Worse fuel economy
  • Fuel smell from the exhaust

Likely causes (most likely first)

  1. Worn or fouled spark plug in cylinder 1
  2. Failing ignition coil or plug wire for cylinder 1
  3. Clogged or failing fuel injector for cylinder 1
  4. Damaged wiring or connector for that coil or injector
  5. Vacuum leak near cylinder 1, such as an intake gasket
  6. Low compression from a valve, ring, or head gasket problem

What you can check yourself

  1. Confirm with your scanner which cylinder is misfiring and whether other codes are present
  2. Find cylinder 1 for your engine using a service diagram, since numbering varies by make
  3. Inspect the coil connector and wiring for damage or corrosion
  4. Swap the cylinder 1 coil with a neighboring cylinder, clear codes, and see if the misfire moves
  5. Remove and inspect the spark plug for wear, oil, or cracks, and swap it to see if the misfire follows
  6. If the misfire stays in cylinder 1, do a compression test or have one done

FRED reads freeze frame and live data, so you can see what the engine was doing when P0301 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace spark plug(s)$100–$400
Replace ignition coil$100–$350
Replace fuel injector$200–$600
Repair coil or injector wiring$100–$350
Mechanical repair (valve or head gasket work)$1,200–$3,500

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0301 FAQ

If the plugs are near or past their service interval, replacing the full set is usually the better value. If they are fairly new, replacing just the bad one is fine.
Swap the coil to another cylinder and clear the codes. If the misfire moves to that cylinder, the coil is bad. If it stays, try swapping the plug the same way.

Related codes