OBD-II trouble code · Powertrain (engine and transmission)

P0156 O2 Sensor Circuit Malfunction Bank 2 Sensor 2

The engine computer sees a general problem with the rear oxygen sensor circuit on Bank 2, such as a signal that is missing, stuck, or out of range. It is often the sensor or its wiring, but exhaust leaks can play a part.

SeverityLow
Safe to drive?Generally safe to drive because the rear sensor mainly monitors the catalytic converter, but repair it to keep emissions monitoring working; stop if the check-engine light flashes.

I'm getting a confusing signal from my rear oxygen sensor on Bank 2. Let's check the wiring and live readings before guessing at parts.

— FRED, speaking as your car

What P0156 means

The PCM continuously checks that the Bank 2 Sensor 2 oxygen sensor signal is present and behaving plausibly once the engine is warm. This is a general circuit code: it was set because the signal did not meet expectations, for example stuck at one voltage, open, or not switching as it should. Bank 2 is the side of a V6, V8 or other V/flat engine opposite cylinder number 1; inline engines do not have a Bank 2. Sensor 2 is the downstream oxygen sensor, mounted after the catalytic converter, and its main job is to check how well the converter is working. Some manufacturers use more specific codes for the same faults, while others use this general one; what exactly triggers it varies by make.

Common symptoms

  • Check engine light on
  • Usually no drivability change
  • Catalyst readiness monitor may not complete
  • May fail an emissions inspection
  • Possible stronger exhaust odor

Likely causes (most likely first)

  1. Failed oxygen sensor
  2. Damaged, open, or shorted sensor wiring
  3. Corroded, loose, or water-filled connector
  4. Exhaust leak near the sensor
  5. Sensor heater failure keeping the sensor too cool
  6. PCM or software issue (rare; check for manufacturer updates)

What you can check yourself

  1. Scan for other oxygen sensor, heater, fuel trim, or misfire codes and note freeze-frame data
  2. Watch the Bank 2 Sensor 2 voltage live with your OBD-II app; a reading stuck at about 0.45 V often indicates an open circuit, while a sensor that never moves suggests a dead sensor
  3. Locate the correct sensor: on the side opposite cylinder 1, after the catalytic converter. A repair manual or online diagram for your exact engine helps, because swapping the wrong sensor is a common and wasted expense.
  4. Inspect the wiring along its full length for melted, rubbed, or broken sections
  5. Disconnect and inspect the connector for corrosion or bent pins
  6. Listen for exhaust leaks near the sensor with the engine cold

FRED reads freeze frame and live data, so you can see what the engine was doing when P0156 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace oxygen sensor$150–$450
Repair wiring or connector$100–$300
Repair exhaust leak near sensor$100–$400
Diagnostic testing at a shop$100–$200

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0156 FAQ

This is a general 'something is wrong with the circuit' code. More specific codes say exactly how the signal is wrong. Either way, live data and a wiring inspection narrow it down.
Only engines with two cylinder banks, such as V6 and V8 engines, have a Bank 2. It is the side opposite cylinder number 1.

Related codes