OBD-II trouble code · Powertrain (engine and transmission)

P0161 O2 Sensor Heater Circuit Malfunction Bank 2 Sensor 2

The built-in heater inside the rear oxygen sensor on Bank 2 is not working correctly, or its circuit has a problem. The sensor needs that heat to work properly, especially right after a cold start.

SeverityLow
Safe to drive?Generally safe to drive since this sensor mainly checks the catalytic converter, but repair it so emissions monitors can run and the car can pass inspection; stop if the check-engine light flashes.

The little heater in my rear oxygen sensor on Bank 2 has quit, so that sensor is slow to wake up. A quick resistance check usually tells us whether it's the sensor or the wiring.

— FRED, speaking as your car

What P0161 means

Oxygen sensors only produce a useful signal when they are very hot, so most have an electric heater inside to bring them up to temperature quickly. The PCM monitors the heater circuit (current draw, voltage, or resistance depending on design) and set this code because the Bank 2 Sensor 2 heater circuit was out of its expected range, such as an open circuit or excessive current. Bank 2 is the side of a V6, V8 or other V/flat engine opposite cylinder number 1; inline engines do not have a Bank 2. Sensor 2 is the downstream oxygen sensor, mounted after the catalytic converter, and its main job is to check how well the converter is working. The most common cause is a burned-out heater element inside the sensor, followed by a blown fuse or damaged wiring. Circuit design and test methods vary by make.

Common symptoms

  • Check engine light on
  • Usually no drivability change
  • Higher emissions after cold start
  • Emissions readiness monitors may not complete
  • May fail an emissions inspection

Likely causes (most likely first)

  1. Failed heater element inside the oxygen sensor
  2. Blown fuse for the oxygen sensor heater circuit
  3. Damaged, melted, or chafed heater wiring
  4. Corroded or loose connector
  5. Faulty heater relay or power feed (on some vehicles)
  6. PCM heater driver fault (rare)

What you can check yourself

  1. Check whether other heater codes are also set; several at once points to a shared fuse or power feed
  2. Check the fuse for the oxygen sensor heaters using the owner's manual fuse chart
  3. Locate the correct sensor: on the side opposite cylinder 1, after the catalytic converter. A repair manual or online diagram for your exact engine helps, because swapping the wrong sensor is a common and wasted expense.
  4. Unplug the sensor and measure heater resistance across the heater pins with a multimeter; compare to the spec for your sensor (often just a few ohms; open or infinite means a dead heater)
  5. With the key on, check for battery voltage at the heater power pin on the vehicle side of the connector
  6. Inspect the harness for spots touching the exhaust

FRED reads freeze frame and live data, so you can see what the engine was doing when P0161 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace oxygen sensor (heater is not serviceable separately)$150–$450
Replace blown fuse and find cause$20–$150
Repair heater wiring or connector$100–$300
Diagnostic testing at a shop$100–$200

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0161 FAQ

No. The heater is built into the oxygen sensor, so if the element is open the whole sensor is replaced.
A fuse usually blows because of a short, such as a damaged wire touching metal or a shorted heater. Replacing the fuse without finding the short often leads to it blowing again.

Related codes