OBD-II trouble code · Powertrain (engine and transmission)

P0153 O2 Sensor Circuit Slow Response Bank 2 Sensor 1

The front oxygen sensor on Bank 2 is reacting too slowly to changes in the exhaust. Oxygen sensors wear out with age, so this often points to a tired sensor, though exhaust leaks and wiring can also cause it.

SeverityModerate
Safe to drive?Usually safe to drive if the engine runs normally, but a slow front sensor can cause poorer fuel control and fuel economy, so fix it soon; stop if the check-engine light flashes.

My front oxygen sensor on Bank 2 has gotten a little slow on the uptake. It's a common sign of age, and a fresh sensor usually gets me sharp again.

— FRED, speaking as your car

What P0153 means

The PCM measures how quickly the Bank 2 Sensor 1 oxygen sensor switches between lean and rich readings, or how fast it responds to events such as fuel shut-off during coasting. It set this code because the response time was slower than the calibrated limit. Bank 2 is the side of a V6, V8 or other V/flat engine opposite cylinder number 1; inline engines do not have a Bank 2. Sensor 1 is the upstream oxygen sensor, mounted before the catalytic converter, and it is the one the computer uses to fine-tune the fuel mixture. Sensors slow down as they age or become coated with deposits from oil burning, coolant, or fuel additives. Exhaust leaks, a weak heater, and wiring issues can also slow the signal. Test methods and limits vary by make.

Common symptoms

  • Check engine light on
  • Reduced fuel economy
  • Slightly rough or uneven idle on some vehicles
  • May fail an emissions inspection
  • Possible increase in exhaust odor

Likely causes (most likely first)

  1. Aged or worn oxygen sensor
  2. Sensor contaminated by oil, coolant, or silicone
  3. Exhaust leak near the sensor
  4. Weak or failing sensor heater
  5. Wiring or connector problem
  6. Engine issues such as misfires that disturb the exhaust signal

What you can check yourself

  1. Check for heater-circuit or misfire codes and address those first
  2. With your OBD-II app, graph the sensor voltage at a steady 2,000–2,500 rpm with the engine fully warm; a healthy front sensor switches quickly and often
  3. Listen for exhaust leaks near the sensor with the engine cold
  4. Locate the correct sensor: on the side opposite cylinder 1, before the catalytic converter (often in or near the exhaust manifold). A repair manual or online diagram for your exact engine helps, because swapping the wrong sensor is a common and wasted expense.
  5. Inspect the wiring and connector for heat damage or corrosion
  6. Consider the sensor's age; original sensors on high-mileage vehicles are common culprits

FRED reads freeze frame and live data, so you can see what the engine was doing when P0153 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace oxygen sensor$175–$500
Repair exhaust leak$100–$400
Repair wiring or connector$100–$300
Diagnostic testing at a shop$100–$200

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0153 FAQ

Yes. They are a wear item, and over many miles they tend to respond more slowly. Many manufacturers list a general replacement interval in the maintenance schedule, which varies by vehicle.
It is not required. Replace the sensor that tested bad. Some owners replace both sensors on the same bank on a high-mileage car for convenience, but that is optional.

Related codes