OBD-II trouble code · Powertrain (engine and transmission)

P0150 O2 Sensor Circuit Malfunction Bank 2 Sensor 1

The engine computer sees a general problem with the front oxygen sensor circuit on Bank 2, such as a signal that is missing, stuck, or out of range. It is often the sensor or its wiring, but exhaust leaks can play a part.

SeverityModerate
Safe to drive?Usually safe to drive short-term if the engine runs normally, but a faulty front sensor can hurt fuel control and the catalytic converter over time, so repair it soon; stop if the check-engine light flashes.

I'm getting a confusing signal from my front oxygen sensor on Bank 2. Let's check the wiring and live readings before guessing at parts.

— FRED, speaking as your car

What P0150 means

The PCM continuously checks that the Bank 2 Sensor 1 oxygen sensor signal is present and behaving plausibly once the engine is warm. This is a general circuit code: it was set because the signal did not meet expectations, for example stuck at one voltage, open, or not switching as it should. Bank 2 is the side of a V6, V8 or other V/flat engine opposite cylinder number 1; inline engines do not have a Bank 2. Sensor 1 is the upstream oxygen sensor, mounted before the catalytic converter, and it is the one the computer uses to fine-tune the fuel mixture. Some manufacturers use more specific codes for the same faults, while others use this general one; what exactly triggers it varies by make.

Common symptoms

  • Check engine light on
  • Reduced fuel economy
  • Possible rough idle or hesitation
  • May fail an emissions inspection
  • Possible stronger exhaust odor

Likely causes (most likely first)

  1. Failed oxygen sensor
  2. Damaged, open, or shorted sensor wiring
  3. Corroded, loose, or water-filled connector
  4. Exhaust leak near the sensor
  5. Sensor heater failure keeping the sensor too cool
  6. PCM or software issue (rare; check for manufacturer updates)

What you can check yourself

  1. Scan for other oxygen sensor, heater, fuel trim, or misfire codes and note freeze-frame data
  2. Watch the Bank 2 Sensor 1 voltage live with your OBD-II app; a reading stuck at about 0.45 V often indicates an open circuit, while a sensor that never moves suggests a dead sensor
  3. Locate the correct sensor: on the side opposite cylinder 1, before the catalytic converter (often in or near the exhaust manifold). A repair manual or online diagram for your exact engine helps, because swapping the wrong sensor is a common and wasted expense.
  4. Inspect the wiring along its full length for melted, rubbed, or broken sections
  5. Disconnect and inspect the connector for corrosion or bent pins
  6. Listen for exhaust leaks near the sensor with the engine cold

FRED reads freeze frame and live data, so you can see what the engine was doing when P0150 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace oxygen sensor$175–$500
Repair wiring or connector$100–$300
Repair exhaust leak near sensor$100–$400
Diagnostic testing at a shop$100–$200

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0150 FAQ

This is a general 'something is wrong with the circuit' code. More specific codes say exactly how the signal is wrong. Either way, live data and a wiring inspection narrow it down.
Only engines with two cylinder banks, such as V6 and V8 engines, have a Bank 2. It is the side opposite cylinder number 1.

Related codes